Roland HPD-15 Manuale Utente Scaricare il pdf (Pagina 81)

Chapter 6 Connecting MIDI Devices

Chapter 6

Refer to the owner’s manual of the receiving device.

5. Press [WRITE] to begin data transmitting.

* If you wish to stop transmission, press [EXIT].

BlkDmp: ALL, SYS, SEQ ALL, PATCH ALL,

GROUP01–10, U0101–1008, TEMPORARY,

U0101–1008-U0101–1008

ALL:

Transmit all settings.

* The settings of the current patch which is not written into

memory (TEMPORARY) will not be transmitted.

SYS:

Transmit system settings (p. 67).

SEQ ALL:

Transmit all data for the user patterns (p. 59) of the

sequencer.

PATCH ALL:

Transmit all user patch settings.

GROUP01–10:

Transmit the settings of all patches in the selected patch

group.

U0101–1008:

Transmit the settings of the selected user patch.

TEMPORARY:

Transmit the settings of the current patch. This allows

you to transmit the state of the settings before pressing

[WRITE] to write them into memory.

U0101–1008-U0101–1008:

Transmit the settings of the specified area of user

patches.

Receiving (Bulk Load)

The HPD-15 receives data that was stored in a sequencer.

Use a MIDI cable to connect the HPD-15’s MIDI IN connector

to the MIDI OUT connector of the external sequencer or the

other HPD-15. Set the HPD-15 play mode.

fig.6-13.e

Send the data from the external sequencer to the HPD-15.

The transmitted settings are reproduced.

When data is received, the data that was previously in the

HPD-15’s memory will be lost.

Never turn the power off while receiving the bulk data and

writing the data into memory. If the power is turned off, the

data will be lost.

Select “Int” for the “Seq Sync” in system settings (p. 68). If

you select other than “Int,” the internal sequencer will begin

playback and won’t receive the data.

External Sequencer

MIDI OUT MIDI IN

HPD-15

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 115 116

Commenti su questo manuale

Nessun commento

Roland HPD-15 Manuale Utente Pagina 81

Commenti su questo manuale