Roland DD-20 Specifiche Scaricare il pdf (Pagina 30)

Settings Made When the Power is Switched ON

Setting the Output Mode

When using the DD-20 while connected to a guitar or bass amp, mixer, or

multitrack recorder SEND/RETURN, you can set the output level (+4 dB) and

method of output from the OUTPUT jacks (A: Direct Sound/B: Effect Sound) to

match the device connected to the DD-20.

1. Switch off the power.

2. While holding down the ON/OFF pedal, switch on the power.

The output mode setting is indicated in the display, and the MEMORY 1–4

indicator corresponding to the current setting flashes.

3. Set the output mode pressing the SELECT button.

fig.44

4. Press the WRITE button.

After the MEMORY Number indicator begins flashing rapidly, the setting is stored

in memory and the unit returns to its ordinary state.

* To cancel the setting change and return the unit to its ordinary state, then before you press

the WRITE button, operate the MEMORY/TAP or ON/OFF pedal.

* Even when this is set to “A: Direct Sound/B: Effect Sound,” if the input is in stereo, then

the output will also be in stereo. Additionally, if the input is mono while nothing is

connected to the OUTPUT B jack (effect sound), then the sounds are not output as “A:

Direct Sound/B: Effect Sound.” If you want to have the output be “A: Direct Sound/B:

Effect Sound,” then set the DD-20 so that “A:DIR, B:EFX” appears in the display.

* This is set at the factory to “Output Mode 1.”

Display Mode Output Level

out1 1 Stereo output -20 dB

out2,

A:DIR / B:EFX

A: Direct Sound/B: Effect

Sound

-20 dB

out3, +4dB 3 Stereo output +4 dB

out4,

A:DIR / B:EFX, +4dB

A: Direct Sound/B: Effect

Sound

+4 dB

Output Mode 1 Output Mode 2 Output Mode 3 Output Mode 4

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 43 44

Nessun commento

Roland DD-20 Specifiche Pagina 30